|
Bleed is the technical term for when the content of a design reaches the very
edge of the paper. Because the printing equipment cannot print to the edges
of paper, it is usual to print the design on over sized paper and then cut it
down to size. However to cope with inaccuracies in registration (the position
of the image on the page) and with the limitations in precision of cutting equipment it is good practice
to have the image larger than will be needed; hence the content 'bleeds' over
the edge.
Figure 1 shows a design of a flyer. We often get designs sent to
us like this, which we cannot then print as desired. To make sure that there
were no thin white borders on this flyer we would have to trim it a bit smaller
than the original design. This isn't much of a problem with flyers as people
don't tend to mind if their design is 4mm smaller but if it is the cover of
a booklet then we would have to trim all the inside pages down by a few millimetres too (which is very time consuming
and therefore expensive).
Figure 1
Figure 2 shows the same flyer as we would print it with the cut lines shown as a black rectangle (don't put a black rectangle on your work :-). Notice how the writing is not only a good distance
in from the edge of the complete image, but also from the edge of the intended
cuts.....
Figure 2
Figure 3 shows the design as we would actually print it, without the black rectangle
but with suitable crop marks that will serve as guides when guillotining. In
this example there is a good deal of bleed but usually an extra 3-4 mm at every
edge will suffice (but the more the better). Remember that unless you really
need your text at the very edge of your design then your text should be set
in from the edge of the cutting line to reduce the chances of us chopping a
bit off. Again 3-4mm should suffice. It is not necessary for you to add the crop marks, we can do it, but
if you do, then please note that each individual mark should be far enough away
from the cutting edge to not touch each other. If your crop marks meet then you will probably end up with bits of them visible on your finished flyer. If you do not add the crop marks,
it is sufficient just to let us know the intended dimensions of the final design,
and the extra bleed that you have added....
Figure 3
|
|
Last Updated ( Wednesday, 20 February 2008 )
|
